News

Feb 15, 2024

what the Honda CR

Q. I took my 2009 Honda CR-V to the dealer for an oil change and the dealer identified a serious structural corrosion issue at the rear. I was told Honda is aware of the problem and will be paying me

Q. I took my 2009 Honda CR-V to the dealer for an oil change and the dealer identified a serious structural corrosion issue at the rear. I was told Honda is aware of the problem and will be paying me something to buy back the vehicle and take it off the road. I’ve been given a courtesy car in the interim. My CR-V has less than 85,000 km on the odometer.— J.S.D., Montreal

… and

Q. My dealer just offered to buy back my 2007 Honda CR-V with 188,000 km on it. They’re prepared to pay the same amount they offered me in trade a full three years ago! According to the dealer, a rear wheel could detach due to a corrosion problem at the rear of the chassis. The dealer gave me just five days to make my decision.— B.L., New Richmond, Que.

A. I can answer both questions here. Honda Canada recently issued a recall on the 2007 through 2011 model-year CR-V for a rusting problem that could result in a rear suspension control arm separating from the vehicle. The recall applies to vehicles in all provinces from Ontario east, which experience heavy road salt usage and humid operating environments. Dealers were instructed to inspect the rear frame stiffeners and to apply corrosion protection. When a vehicle does not pass the inspection, Honda will offer to repurchase it.

Honda dealers were instructed to test the rear chassis stiffener of recalled vehicles. If they are able to perforate the metal using a testing tool (it’s a special mallet with a spike attached) then the vehicle “fails” and the first remedy offered is a buyback. I believe the buyback is a non-negotiable value plus a 15% markup for any inconvenience. Generally, a repurchase offer based on a standard formula benefits the owners of vehicles in rough condition and is less advantageous to owners of vehicles in good condition, or with low mileage.

Honda’s recall does allow for the repair of vehicles that owners would prefer to keep. However, this appears to be a tertiary remedy to be suggested after either rustproofing has been applied or a customer turned down the buyback offer.

You may be surprised to learn that Honda would prefer to buy your vehicle back instead of paying for repairs and keeping it on the road. Structural repairs are expensive and time-consuming, with the potential to overwhelm dealers with in-house body shops (and in fact, Honda has made provision for dealers to sublet the repair to independent shops).

Undertaking a major repair on a 10-year-old vehicle opens the door to disagreements with the owner over who will pay for additional work that might be required to other components in the area related to the repair; so generally, taking the buyback offer is the better way to go unless it significantly undervalues the vehicle.

Administering a major corrosion recall is a complicated matter. For example, while waiting for parts to arrive and repairs to be completed, Mazda Canada has been paying some owners of the 2009 through 2010 model-year Mazda 6 to drive courtesy vehicles for months.

Share this article Share on Facebook Share on Twitter Share on Linkedin Share on Reddit Share on Email

Your email address will not be published. Required fields are marked *

Δ

I have a 2003 Honda CRV that won’t pass inspection due to rust and corrosion beneath both sides running along the both doors and underneath the real axle. Would a Honda dealer in the United States buy this CRV in Pennsylvania?

I had a 2005 Honda Element and two years ago the rear driver side tire assembly came completely off the frame due to this corrosion problem while I was coming up to stop at an intersection. Had the trailing arm lasted another 50 feet I would have turned onto a bridge with apposing traffic and could have been killed or seriously injured along with my passenger. There was no alert of this problem at this time. I had to junk it as Honda was not indicating any responsibility at that time. What is Honda proposing to offer owners who have already been subject to failure due to this problem while driving?

Thanks for sharing your experience with your own vehicle. We invite you to email your question to [email protected], where it will be considered for a future response by one of our expert columnists. For personal advice, we suggest consulting with your financial institution or a qualified advisor.

I had my 2008 Honda CRV at the shop for a starter repair and he found the rear axle rust damage. It is barely attached on one side. I read somewhere that these Canadian CRVs were manufactured in Ohio, which is where I bought my Honda CR-V used six years ago. I will reporting my issue on Monday as they are not available over the weekend. Honda should be covered all of the vehicles in this batch, not just the ones in Canada.

I got a Honda crv 2008 in Nigeria and both rear suspension actually disengaged at various times due to massive corrosion. Cost a lot to tow and fix, the mechanic who worked on the car been dubious also didn’t help. The experience made me develop a huge dislike for honda. Don’t think I will do another after this

Over the summer the control arm on the rear driver’s side of my 2008 Honda CRV became detached from the vehicle. It was being driven by a family member at the time and took him a full 100 yards before he was able to bring the vehicle to a stop. According to my local Honda service center, who have seen photos of my vehicle, it is not repairable. Despite months of calling Honda, they will do nothing. I submitted a mediation request via the Attorney General of my state. Honda never responded to them. There are numerous complaints on the NHTSA website regarding this very serious safety issue and it puzzles me as to why they are able to declare it a safety issue in Canada yet not have to do anything about it in the U.S. The A.G.’s should file suit before this costs people their lives.

The exact same scenario happened to me. Should these issues not have been picked up on a AMVIC inspection or an out of province inspection?

I took my 2009 Honda CR-V to the dealer for an oil change and the dealer identified a serious structural corrosion issue at the rear. I was told Honda is aware of the problem and will be paying me something to buy back the vehicle and take it off the road. I’ve been given a courtesy car in the interim. My CR-V has less than 85,000 km on the odometer. — J.S.D., Montreal … and Q. My dealer just offered to buy back my 2007 Honda CR-V with 188,000 km on it. They’re prepared to pay the same amount they offered me in trade a full three years ago! According to the dealer, a rear wheel could detach due to a corrosion problem at the rear of the chassis. The dealer gave me just five days to make my decision. — B.L., New Richmond, Que. A. I can answer both questions here. Honda Canada recently issued a recall on the 2007 through 2011 model-year CR-V for a rusting problem that could result in a rear suspension control arm separating from the vehicle. The recall applies to vehicles in all provinces from Ontario east, which experience heavy road salt usage and humid operating environments. Dealers were instructed to inspect the rear frame stiffeners and to apply corrosion protection. When a vehicle does not pass the inspection, Honda will offer to repurchase it. Honda dealers were instructed to test the rear chassis stiffener of recalled vehicles. If they are able to perforate the metal using a testing tool (it’s a special mallet with a spike attached) then the vehicle “fails” and the first remedy offered is a buyback. I believe the buyback is a non-negotiable value plus a 15% markup for any inconvenience. Generally, a repurchase offer based on a standard formula benefits the owners of vehicles in rough condition and is less advantageous to owners of vehicles in good condition, or with low mileage. Honda’s recall does allow for the repair of vehicles that owners would prefer to keep. However, this appears to be a tertiary remedy to be suggested after either rustproofing has been applied or a customer turned down the buyback offer. You may be surprised to learn that Honda would prefer to buy your vehicle back instead of paying for repairs and keeping it on the road. Structural repairs are expensive and time-consuming, with the potential to overwhelm dealers with in-house body shops (and in fact, Honda has made provision for dealers to sublet the repair to independent shops). Undertaking a major repair on a 10-year-old vehicle opens the door to disagreements with the owner over who will pay for additional work that might be required to other components in the area related to the repair; so generally, taking the buyback offer is the better way to go unless it significantly undervalues the vehicle. Administering a major corrosion recall is a complicated matter. For example, while waiting for parts to arrive and repairs to be completed, Mazda Canada has been paying some owners of the 2009 through 2010 model-year Mazda 6 to drive courtesy vehicles for months.

This exact scenario happened to me! Should this not have been caught in an out of province inspection or an AMVIC inspection? I mean what’s the purpose of either of those inspections when your car can literally be taken off the road in a matter of minutes and you are left without any warnings or options. I think the inspection process is greatly flawed. But they are more than happy to sell you a brand new car!!!

I have a Honda CRV MK3 2007. We were lucky we just pulled of the M3 when the rear driver side axle gave way due to corrosion. We are lucky we are still alive. Why is this not picked up on MOT and why has HONDA not warned owners of this?

Sitting awaiting a recovery truck with one rear wheel hanging off right now, absolute fluke that noone was killed. Just passed its annual road safety test a couple of months ago too. UK based so doubt honda will do anything to help 🙁